Learn to make an adorable zippy pouch using unique stitches from the Janome Skyline S7.Materials Needed:
- 1 Fat quarter of printed fabric
- 1 Small scrap of contrasting solid fabric (approximately 6”x6”)
- 1 Small scrap of contrasting fabric (approximately 13”x10) for lining, could use left over fabric from FQ
- Small scrap of batting (approximately 12”x12”)
- 1 9” zipper
- Aurifil 40wt thread (try the Sweet Pea box by Sew Caroline)
Fabrics Featured: Happy Home and Chalk and Paint by Sew Caroline for Art Gallery Fabrics
Cut from printed fabric:
(2) 3.5” x 6”
(1) 6” x 9”
(2) 2” x 2”
Cut from solid fabric:
(1) 3.5” x 6”
Cut from Batting
(1) 6” x 9”
(3) 3.5” x 6”
Layer the solid fabric on top of one of the 3.5” x 6” pieces of batting. Baste with safety pins if necessary and sew using the preferred stitches from your Janome Skyline S7 straight lines across. You can sew up and down or from one side to the other. Layer two of the printed fabrics on top of the other coordinating batting, baste with safety pins if necessary and “quilt” these pieces using unique stitches as well.
Sew the three pieces together using a 1/4″ seam allowance. Repeat Step Two for the back.
Press two of the raw edges of the 2″ x 2″ squares towards the center and then fold and press the folded edges together. Place these on the ends of your zipper and top stitch.
Repeat for the back piece.
Unzip the zipper about half way and align the front and back right sides together and the lining pieces right sides together. Pin and sew around the three open edges. Leave about a 3″ opening in the lining for turning.
Add gussets to each corner by aligning the side seam with the bottom seam (with right sides still facing. and marking 1″ from the point using a straight line. Sew across this line and cut the excess fabric in the corner. Repeat this for the remaining three corners.
Turn the zip pouch to the right side through the hole you left in the lining. Carefully top stitch the opening closed and press your zip pouch.
Enjoy your new zippy pouch!
Disclaimer: This post and the corresponding tutorial was created as part of my partnership with Janome and their On Loan / Artisan program. The content and thoughts expressed in this post are my own.